![]() Connect the other end(s) of the antenna downlead(s) to the preamplifier. Slide the weather boot(s) over the cable connector(s) and boot collar(s) on the antenna(s).ĥ. You can secure the coaxial downleads to the mast with weatherproof tape or cable ties. Leave enough slack in the cable(s) to form a drain loop. Connect the antenna downlead(s) to your antenna(s). Slide the weather boots over the antenna downlead(s).Īttach F-connectors to the coaxial cable(s) if necessary.Ĥ. NOTE: For best results, mount the preamplifier as close to the antenna as possible.ģ. Then place the washers on both ends, followed by the nuts. Put the preamplifier on the U-bolt as shown. Make sure you mount it within easy reach. Position the U-bolt on the antenna mast where you want to mount the preamplifier. Mount the preamplifier to your antenna mast. IMPORTANT: Make sure the weatherproof covers for these switches are back in place before you mount the preamplifier to your antenna mast.Ģ. Please note, however, that switching the FM trap off may affect TV reception performance. ![]() If you use your antenna for FM as well as for TV broadcasts, switch the FM trap off. NOTE: For best performance, keep the FM trap in the ON position. (The switch is protected by a weatherproof cover that you'll have to remove first.) If you would like to turn it off, use a small flathead screwdriver to set this switch to OFF. The preamplifier’s FM Trap is set to ON by default. If you want to use it with separate VHF and UHF antennas, use a small flathead screwdriver to set the switch on the bottom of the preamplifier to SEPARATE. Set the VHF/UHF and FM TRAP switches on the bottom of the preamplifier.īy default, the preamplifier is set to work with a single, combined VHF/UHF antenna. The TVPRAMP1R is engineered for digital signals, so it outperforms old preamps made for analog.ġ. The TVPRAMP1R is designed specifically to improve the performance of outdoor antennas in low signal strength areas, extending antenna range to give you the most channels and best reception possible. Installing the RCA TVPRAMP1R Outdoor Pre-Amplifier
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |